3com 3CNJ95 Manuel du propriétaire télécharger pdf (Page 43)

Appendix F: Setting up the Network Cabling at Your Site

Appendix F: Setting up the Network Cabling at

Your Site

The network cabling at your site (from the wiring closet to the

wall or cubicle opening) may already be installed. If it is not,

install the cabling following these general guidelines.

1 Connect one end of an Ethernet cable to your network.

Usually, this connection is done in a network wiring closet,

via the patch panel.

2 Terminate the other end of the cable at the location where

the NJ95 is being installed using a female RJ-45 connector.

Refer to the connector manufacturer’s instructions for

terminating the cable. Be sure to test the connector and

verify it is working.

To ensure proper horizontal cabling functionality, adhere to the

following network cabling standards during installation:

■ ANSI/TIA/EIA-568 Commercial Building Telecommunications

Cabling Standard

■ ANSI/TIA/EIA-569 Commercial Building Standard for

Telecommunications Pathways and Spaces

■ British Standard Institute (BSI): BS 4664:1970

■ DIN

CAUTION: It is recommended that a professional cable

installer perform these procedures. Be sure to adhere to

local safety and regulatory codes during the cable

installation.

davinci_gde.book Page 37 Thursday, December 26, 2002 4:52 PM

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 59 60

Pas de commentaire

3com 3CNJ95 Manuel du propriétaire Page 43